The CLP001 is an ergonomic probe handle with two permanent targets. The entire tool is autoclaveable and extremely durable. We stock this tool with either a short straight shaft (75 mm) or with a bayonet shaft (145 mm).
DK001 Steam-sterilizable pre-cut adhesive markers
DuraMarks are tracking targets (Xpoints), made of a durable adhesive material tested to sustain over 100 cycles of steam sterilization according to ISO 13402-1995. Each kit contains 8 single Xpoints (r=12mm), 8 oval dual Xpoints (r=12mm) and one large "cut your own" sheet with a grid of 63 Xpoints.
All the other accessories listed below are custom orders. Contact info@clarontech.com for details.
CLP001 Probe Body with custom stem (Custom Order)
The probe can also be fitted with other custom shafts.
Attachments:
Straight shaft with rounded tip, 40 mm long;
Straight shaft with rounded tip, 75 mm long;
Straight shaft with sharp tip, 75 mm long;
Straight shaft with conical tip, mid sharp 75 mm long;
Straight shaft, conical tip, mid sharp 210 mm long;
Bayonet shaft with rounded tip, 145 mm long;
Bayonet shaft, conical tip, mid sharp 145 mm long;
Exaggerated bayonet shaft with rounded tip, 115 mm;
Digitizing Ball-tips 0.5- 0.5 mm diameter, 25 mm long;
Extension shafts for ball tips 35 mm long, can be cascaded
This adaptor arm enables attaching the MicronTracker camera directly to the Mayfield head-clamp via the starburst adaptor. The multi-jointed arm enables camera positioning to a wide range of positions. This enables line of sight to be maintained while eliminating the need to independently mount the camera. It also acts as an implicit dynamic referencing system with no need to independently track the skull.
The arm is made of stainless steel, with central locking handle that simultaneously locks all joints. Camera mounts directly to distal end of the arm, and proximal end mounts directly to Mayfield-style starburst.
The CLPFL001 fluoroscope system is designed for fluoroscope calibration and tool tracking during virtual fluoroscopy. It allows mounting of the MicronTracker camera directly to the fluoroscope. The system includes 2 grid plates and an articulating mounting arm, enabling simultaneous image dewarping, calculation of x-ray beam properties and tool tracking. By mounting the camera directly to the fluoroscope it is not necessary to explicitly track the fluoroscope.
The position arm has central locking handle that simultaneously locks all joints. Camera mounts directly to distal end of the arm. Dewarp and calibration grid plates mount to proximal end of arm. Plate assembly mounts to fluoroscope image intensifier using quick-release latching system enabling sharing between fluoroscopes and easy mounting and removal.
Supports Philips BV29-9", Philips BV300 12", Philips BV300-9", OEC9600, OEC9800 9", OEC 9800 12". Lead time typically 4-8 weeks. Others available on request at longer lead time.
Dual-sided aluminum reference body with checkerboard patterns permanently attached. Attachment compatible with a wide range of screws and clamps.
A number of small clamps and screws, extenders, multi-position elbow adaptors etc. are also available. While they may not be the final solution for your particular application, these tools allow quick prototyping and testing of ideas prior to specification of a custom solution.
